To connect your device to the VPN, you need to retrieve its WireGuard configuration. This guide walks you through the steps to download the configuration file, ensuring your device is ready for secure VPN access.

Before you start

Ensure you have an active account and are logged in.
Your device must be registered in the system.

Steps to Retrieve Device Configuration

Log in to your account. Use your credentials to access the system. If you haven't set up your account yet, refer to the "Initial Setup" article.
Navigate to the devices section. Once logged in, locate and click on the section dedicated to device management.
Select your device. From the list of registered devices, find and select the device for which you need the configuration.
Download the configuration file. After selecting your device, look for an option to download the WireGuard configuration file. Click to download it to your device.
Configure your device for VPN access. Use the downloaded configuration file to set up your device for VPN access. Follow any additional instructions specific to your device type.

Example Configuration File

Below is an example of what a WireGuard configuration file might look like. You can use this as a reference to understand the structure:

[Interface]
PrivateKey = <Your-Private-Key>
Address = 10.0.0.2/24
DNS = 8.8.8.8

[Peer]
PublicKey = <Server-Public-Key>
Endpoint = vpn.example.com:51820
AllowedIPs = 0.0.0.0/0
PersistentKeepalive = 25

If something goes wrong

Cannot find the device: Ensure the device is registered. Refer to the "Registering a Device" article for guidance.
Configuration file won't download: Check your internet connection and try again. If the issue persists, log out and back in, then repeat the steps.
Configuration file is incorrect: Verify that you selected the correct device. If the problem continues, contact support for assistance.